OEM 2008 Cadillac XLR ABS Control Module

2008 Cadillac XLR ABS Control Module Parts and Q&A

• Q: How to replace the ABS Control Module in LH2 - 8 CYL, 4.6L, DOHC, HO on 2008 Cadillac XLR?

  A: The replacement of abs control modules in lh2 - 8 cyl, 4.6l, dohc, ho vehicles demands a off position Ignition Switch before disconnecting the negative Battery Cable to avoid harming the ABS Control Module/ebtcm units. Angling the ignition key to off will activate a 2-minute waiting time for high-speed lan control modules to become inoperative. Before you begin the replacement you should disconnect the negative Battery Cable while cleaning the ABS Control Module to brake pressure modulator valve (BPMV) area and raise the vehicle. The ABS Control Module and connector will be more accessible after removal of the two bpmv bracket-to-crossmember mounting bolts so stabilize the abs modulator assembly. Route the electrical connector away from the brake fluid pressure sensor while using a finger to activate the lock mechanism and simultaneously push the cam until it disconnects the ABS Control Module connector. House the two bpmv retaining bolts then work to detach the ABS Control Module unit from the bpmv pack. The bpmv sealing surface needs denatured alcohol cleaning before you place the ABS Control Module motor connector into position and install the ABS Control Module onto the bpmv while aligning electrical terminals. The 4 bolts should be installed diagonally across the device and tightened to reaching 5 n.m (44 lb in). Connect the ABS Control Module electrical connector while making sure the cam is in proper position before attaching the brake fluid pressure sensor connector. Tighten the two bolts attaching the bpmv bracket to the crossmember until they reach 27 n.m (20 lb ft), before lower the vehicle while also reconnecting the negative Battery Cable. When replacing an ABS Control Module the programming steps must be completed then a diagnostic system check must run to verify proper system functionality.