Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following 2007 Buick Lucerne Submodels:
CX, CXL, CXL Special Edition, CXS, Super | 6 Cyl 3.8 L GAS, 6 Cyl 3.9 L FLEX, 6 Cyl 3.9 L GAS, 8 Cyl 4.6 L GAS
2007 Buick Lucerne TPMS Sensor
With a comprehensive array of OEM 2007 Buick Lucerne TPMS Sensor, from fuel pumps to door handles, our website is a one-stop-shop for your needs. All our genuine 2007 Buick Lucerne TPMS Sensor are backed by the manufacturer's warranty and are offered at competitive prices in the market. Rest assured, you can shop with complete confidence.
2007 Buick Lucerne TPMS Sensor Parts and Q&A
Q: How to replace the TPMS Sensor (Snap In Style) on 2007 Buick Lucerne?
A: The tire pressure sensor replacement requires the vehicle on a suitable support while you remove the tire/wheel assembly first. You should remove the tire from the rim while using a fresh Schrader(R) tire pressure monitor (TPM) along with a new TORX screw during installation. Gently pull the tire pressure sensor off its valve stem by removing its TORX screw while protecting aluminum wheel clear coatings against corrosion and peel damage. Pull the tire pressure valve stem from the rim opening after completing its removal process. After installation always make sure the valve's flat surface matches the enclosure's snap flats while noting that TPM valves and TORX screws function only once. install the tire pressure sensor on the valve stem and tighten the new TORX screw to 1.3 N.m (11.5 lb in). Apply an approved gear lubricant during tire mounting while steering clear of both silicon-based and corrosive base compounds which may harm the tire or rim material. Use tire soap to treat the rubber portion of the valve stem before using the tire valve stem mounting tool to push the valve stem along the parallel direction of the valve hole on the rim. Following tire mounting install the wheel assembly onto the vehicle and lower it to check the tire pressure sensors.