OEM 2005 Chevrolet SSR Oil Pressure Switch

2005 Chevrolet SSR Oil Pressure Switch Parts and Q&A

• Q: How to replace the engine oil pressure switch on 2005 Chevrolet SSR?

  A: The replacement of engine oil pressure sensor and switch demands the use of an oil pressure sensor socket (J 41712) among essential tools. Start by taking out the left engine sight cover then clean the area where the oil sensor/switch is located. First disconnect the vacuum hose of the power Brake Booster then remove the electrical connector for the oil pressure sensor/switch . Use the oil pressure sensor socket (J 41712) to remove the oil pressure sensor/switch. When reinstalling the old sensor use threadlocker sealant gm p/n 12346004 (Canadian P/N 10953480) or an equivalent threadlocker solution. You should use the oil pressure sensor socket (J 41712) to install the oil pressure sensor/switch before tightening it to 20 nm (15 ft. Lbs.). Reinstall the left engine sight cover while completing the following steps: reconnect the electrical connector for the oil pressure sensor/switch and reinstall the vacuum hose for the power Brake Booster.