OEM 2004 Chevrolet Aveo Release Bearing

2004 Chevrolet Aveo Release Bearing Parts and Q&A

• Q: How to replace the clutch release bearing on 2004 Chevrolet Aveo?

  A: The process starts by removing the transaxle from the vehicle then following with the release arm and Release Bearing. First remove the release shaft along with its bushing. Then use dt 47514 (DW210-040) bushing remover/installer and a hammer to extract the no. 2 bushing and seal from their position. First remove the release shaft before inserting the tap (M16 x 1.51) into the bushing. The end of dt 47513 (DW210-030) bushing joint pipe connects to j 2619-01 (09930-30102) to pull out the bushing. Check the Release Bearing for signs of damage or noise or wear while examining the shaft for warping and the fork for wear. Replace damaged components as needed. Dt 47513 (DW210-030) bushing, bearing installer plus a hammer enable the installation of the release shaft no. 1 bushing and release shaft through application of grease to both components. To assemble release shaft no. 2 use a hammer with dt 47514 (DW210-040) to set both bushing and seal. Once complete apply multipurpose grease to the transaxle input shaft's spline area and the Release Bearing bore. Chain the process by fitting the Release Bearing followed by the release arm and returning the transaxle to its vehicle position.