OEM 2004 Cadillac SRX Throttle Body

2004 Cadillac SRX Throttle Body Parts and Q&A

• Q: How to replace the throttle body assembly on 2004 Cadillac SRX?

  A: Start by turning off ignition then extract the air cleaner intake duct before replacing the throttle body assembly. Use your fingers to pull apart connector pieces since tools such as pliers or screwdrivers will damage components. It is important to use finger pressure on both connector latches before gently pulling the wires straight back to avoid damaging the wires. Start by disconnecting the throttle body electrical connector, unlock the wiring harness conduit for positioning before removing the throttle body bolts. Extract the throttle body unit as well as its gasket with precaution. Begin by wiping off all throttle body mounting surfaces of gasket or seal remnants before you put in the throttle body alongside its NEW gasket. Tighten the throttle body bolts to 10 N.m (89 lb in) torque. After installing the throttle body electrical connector and wiring harness conduit you must place the air cleaner intake duct back in position. The idle learn procedure should be conducted before using a scan tool to erase all Diagnostic Trouble Codes.