OEM 2004 Cadillac DeVille Wheel Bearing

2004 Cadillac DeVille Wheel Bearing Parts and Q&A

• Q: What tools are required to service and repair the wheel bearing and hub with RPO FE7 on 2004 Cadillac DeVille?

  A: Front/rear spindle remover model j 28733-b is needed to service Wheel Bearing and hub unit fe7. First lift the vehicle and take out the tire and wheel components. Place a flat tool between the caliper and rotor to stop the rotor from turning. Next remove the wheel display shaft nut and rotor. Remove the sensor connector plug from the dust shield and its bolted Wheel Bearing and hub location. Employ the front/rear spindle remover (J 28733-B) tool to detach hub and bearing assembly from the axle assembly and successfully remove both parts from the drive axle. Wash the knuckle mounting area, bore, and chamfer to help the bearing and knuckle seat correctly. Handle the Wheel Bearing and hub only by the mechanical parts because the abs sensor wire needs protection. Set the dust shield into place exactly to protect the bearing outboard lip seal before building up the Wheel Bearing and hub unit onto the drive axle. Free the Wheel Bearing hub and bearing by tightening the drive axle nut and fastening the Wheel Bearing hub and bearing bolts at 152 nm (112 ft. Lbs.). Reattach the front wheel speed sensor connector and lock it into place on the dust shield before putting on the brake rotor. Put a large flat tool into the caliper and rotor to immobilize the rotor before tightening the wheel axle nut to 230 nm (170 ft. Lbs). Place the wheel and tire onto position before letting the car down to the ground.