How to service the knock sensor on 2002 Chevrolet Venture?

Starting by shutting off ignition power you must then elevate the vehicle with proper support systems while performing service on the knock sensor. First remove the knock sensor (KS) from its position by disconnecting its wiring harness connector. Then pull the KS out from the engine block. Installation of the KS requires sensor thread bins to remain untubeled due to factory thread coating so that the sensor's detonation detection capability remains uncompromised. Secure the KS into its place in the engine block while tightening it up to 19 N.m (14 lb ft). The wiring harness connector should be reconnected to the knock sensor while the vehicle lowers itself.

OEM 2002 Chevrolet Venture Knock Sensor

Engine Knock Sensor

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Knock Sensor found

View related parts
2002 Chevrolet Venture Knock Sensor Part Number: 10456238
Product Specifications
- Other Name: Sensor, Distributor (Also Knock Sensor)
- Item Weight: 0.50 Pounds
- Item Dimensions: 3.1 x 2.0 x 2.0 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 10456238
- Warranty: This genuine part is guaranteed by GM's factory warranty.
More Info
Fits the following 2002 Chevrolet Venture Submodels:
- Base, LS, LT, Plus, Value, Warner Bros. | 6 Cyl 3.4 L GAS

2002 Chevrolet Venture Knock Sensor

With a comprehensive array of OEM 2002 Chevrolet Venture Knock Sensor, from fuel pumps to door handles, our website is a one-stop-shop for your needs. All our genuine 2002 Chevrolet Venture Knock Sensor are backed by the manufacturer's warranty and are offered at competitive prices in the market. Rest assured, you can shop with complete confidence.

2002 Chevrolet Venture Knock Sensor Parts and Q&A

Q: How to service the knock sensor on 2002 Chevrolet Venture?
A: Starting by shutting off ignition power you must then elevate the vehicle with proper support systems while performing service on the knock sensor. First remove the knock sensor (KS) from its position by disconnecting its wiring harness connector. Then pull the KS out from the engine block. Installation of the KS requires sensor thread bins to remain untubeled due to factory thread coating so that the sensor's detonation detection capability remains uncompromised. Secure the KS into its place in the engine block while tightening it up to 19 N.m (14 lb ft). The wiring harness connector should be reconnected to the knock sensor while the vehicle lowers itself.