OEM 2001 Cadillac DeVille Rack and Pinion Boot

2001 Cadillac DeVille Rack and Pinion Boot Parts and Q&A

• Q: How to replace the Rack and Pinion Boot on 2001 Cadillac DeVille?

  A: When performing Rack and Pinion Boot replacement on vehicles use the j 22610 service boot clamp installer (J 22610). Start your proceeding by disconnecting the outer tie rod and detach the hex jam nut present on the inner tie rod assembly . You will find the tie rod end clamp on the Rack and Pinion Boot so use side cutters to remove it before discarding this component. Inspection of the Rack And Pinion gear assembly requires boot removal followed by examination of damage and internal oil leak condition. Dump all oil from the area then thoroughly clean the Rack and Pinion Boot with solvent. To build the Rack and Pinion Boot assembly apply boot clamp onto the boot unit before adding grease to both component assemblies. Then fit the boot onto the inner tie rod assembly. Check the boot's alignment by touching it with your hand to prevent buckling then place it correctly into the shaft assembly groove. Use the j 22610 to clamp and form the boot clamp on the boot before using the plier to set the tie rod end clamp. You must reattach the hex jam nut to the inner tie rod assembly.