OEM 2001 Cadillac DeVille Brake Pad

2001 Cadillac DeVille Brake Pad Parts and Q&A

• Q: How to replace the rear brake pads (J55) on 2001 Cadillac DeVille?

  A: Before starting the replacement of j55 rear brake pads you need to observe the brake master cylinder fluid level in the reservoir and drain it down to midpoint when the fluid level shows above this point. While the vehicle is lifted position the wheel to match its flange alignment on the axle before taking off the tire and wheelunit. Position a large c-clamp on top of the brake caliper while wedging the brake piston with an old inner pad or wood block. Adjust the clamp to decrease piston size almost enough to pass through the rotor. Separate the c-clamp and wood pad once you push the piston back. After that, take out the brake pads from their mountings to inspect the pad retainers. Look for damage on the Brake Caliper Bolt suspension boots and replace them if found. Also examine the caliper pin bolt for corrosion buildup and replace it when necessary. Test the brake caliper piston boot condition then fix or replace the caliper when it shows damage. Put Brake Pad retainers into caliper bracket while adding high-temperature silicone to all rear caliper fastening points. Install one Brake Pad direction then the other pad into the caliper bracket. Place the caliper over the pads and pin brackets before tightening caliper pin bolts to 31 nm (23 ft. Lbf). Put back the tire and wheel unit and let the vehicle down. While the motor remains turned off apply the brake pedal until it reaches two-thirds of its range and permit it to revert slowly. Apply brakes for 15 seconds then repeat to ensure both pistons and pads remain in good position during installation. End by adding brake fluid to the reservoir until it reaches normal range and then spin the brake pads gently against the rotors.