OEM 2000 Chevrolet Tracker Starter

2000 Chevrolet Tracker Starter Parts and Q&A

• Q: How to service and repair the starter motor on 2000 Chevrolet Tracker?

  A: Begin Starter motor servicing by extracting it from the vehicle. Different mark spots should be drawn on both the drive housing and solenoid since this helps maintain correct solenoid positioning. First disconnect the retaining nut and field coil lead wire from the solenoid while proceeding to remove its two screws and solenoid after that. Disassembling the Starter solenoid must be avoided as a new one should be installed if it shows any faults. Thoroughly check the plunger and spring's condition before getting new replacements if needed. Take the drive housing end cover along with two screws and two bolts off the housing before extracting the commutator end bushing. You should also remove the washers. Mark the field frame and the drive housing directly for assembly alignment by using scribes. Separate the drive housing from the field frame while also taking out the pinion drive lever. Before extracting the Armature from the field frame apply gm p/n 1051344 chassis grease gm p/n 1051344 to the Armature bearing when the process permits its removal. Begin by extracting the idle gear retainer together with its three idle gears from the drive housing followed by removing the pinion drive lever seal and the plate. The gear shaft assembly extracting step includes removal of the pinion drive lever from the drive housing before moving the overrunning clutch stop ring toward the overrunning clutch assembly for removing the overrunning clutch retaining ring. The final operation is to remove the overrunning clutch stop ring with the overrunning clutch assembly from the gear shaft assembly to take out the internal gear of the shaft.